Owner's Manual

Page 5 of 6
Initial start up:
1. After initial power up or when RESET button is pressed, the transmitter is reset. The
reset button is located close the battery door.
2. During system reset, all features of the LCD will be visible. After one second, the LCD
will be initialized. A typical reset display is shown right. After reset the transmitter is
operating. The room temperature is shown as right.
Manual Mode:
1. Press the button once to turn on the appliance.
2. Press the button once again to turn off the appliance.
3. Press °C/°F button to select between °C and °F display.
Thermostatic mode:
1. Press the AUTO button to enter the thermostatic mode. “SET” temp icon will
appear on the lower LCD screen
2. In thermostatic mode, press the  button or  button to set the desired set
temperature.
3. Once the setting is completed, the transmitter will automatically turn on the
fireplace when the room temperature is below the set temperature and turn off the
appliance when the room temperature is above the set temperature within 1 degree.
4. There will be a slight delay in the response of the unit (on/off) to a temperature.
Room temperature is monitored every 3 minutes.
5. Press the Auto button again to exit the thermostatic mode (Return to Manual
Mode). The “SET” temp icon will disappear on the lower LCD display. The
transmitter will be in the manual on/off mode
Backlight
The backlight color will change according to the current temperature range. If the room temperature is over
78℉(26℃) , then the backlight will be Red. If room temperature is less than 61℉(16℃) , the backlight will be
Green. Backlight will be Blue if the room temperature is between 61-78℉(16-26℃) .When any key is pressed the
backlight will turn on for 6 seconds and then turn off.
Low-battery detection:
1. When the battery voltage of remote less than 2.2V, the low battery icon will flash. The
battery will be checked every minute. If the battery voltage of remote is less than 2.0V, the
remote will send the flame off command to the receiver and turn off the flame.
2. The transmitter will not operate with low batteries. Change the battery before the battery
is too weak for normal operation. TURN THE UNIT OFF BEFORE REPLACING
BATTERIES.
Child-proof protection:
1. Press and hold LOCK buttons simultaneously for 3 seconds to enter child-proof mode.
2. The transmitter will not work until child-proof mode is deactivated by pressing the ON
and OFF buttons simultaneously for 3 seconds again to exit child-proof mode.