Owner's Manual

Page 4 of 5
2. The remote control will not work until child-proof mode is deactivated by pressing the ”ON”and”MODE”
buttons at same time for 5 seconds again to exit child-proof mode.
TRANSMITTER WALL CLIP
The transmitter can be hung on a wall using the clip provided. If the clip
is installed on a solid wood wall, drill 1/8” pilot holes and install with the
screws provided. If it is installed on a plaster/wallboard wall, first drill
two 1/4” holes into the wall. Then use a hammer to tap in the two plastic
wall anchors flush with the wall; then install the screws provided.
Receiver:
Slide Switch:
1. ON position: the system will remain on until the slide switch is placed
in the OFF or RS position.
2. RS position: the system will only operate if the remote receiver receives a signal from the transmitter.
3. OFF position: the system is off. The slide switch should be placed in the OFF position if you will be
away for an extended period of time. If the remote receiver is mounted out of children’s reach, the OFF
position also functions as a safety device by both turning the system off and rendering the receiver
inoperable.
TESTING YOUR NEW REMOTE CONTROL SYSTEM
1. Light your gas appliance following the appliance lighting instructions that come with the appliance.
Confirm that the pilot light is on; it must be in operation for the remote control to operate the main gas
valve. Appliance control knob must be in the ON position. Appliance ON/OFF switch must be in OFF
position.
2. Slide the 3 position button on the remote receiver to the ON position. The main gas flame should ignite.
3. Slide the button to OFF. The flame should extinguish (the pilot light will remain on).
4. Slide the button to RS (the center position), then press the transmitter to turn the system to ON. The main
gas flame should ignite.
5. Press the transmitter to turn the system to OFF. The flame should extinguish (the pilot light will remain
on).
TROUBLESHOOTING
Symptom
Causes
Action
battery icon on LCD on
transmitter.
Low Battery
Replace batteries.
Display is blank
Low Battery
Check battery installation and replace
batteries.
Appliance does not come
on.
1. DIP (Privacy) switch setting on
transmitter does not match receiver
1. Make sure the transmitter match receive
at first.
2. Transmitter measures temperature
exceeding 99 degrees and shows
“HI” on LCD disply.
2. Move transmitter to a cooler place and
wait until temperature drops below 99
degree.
3. Distance between the transmitter
and receiver is more than 30 feet
3. Make sure the operating distance is less
than 30 feet
Receiver cannot receive
signal.
1.Receiver is installed in an enclosure
1. Make sure the receiver is not inside a
tight enclosure.