User's Manual

CrossFire – A revolution in RF Transport for In Building Wireless
User Manual
79 Revision 1.0.1
3. Set the uplink and downlink operating frequency band limits for channels 1, 2, 3 and 4.
(See step 1 in Figure 7-4.)
4. Set the uplink and downlink centre frequencies and the bandwidth for signals 1, 2, 3 and 4.
(See step 2 in Figure 7-4.)
5. Click Set to validate the parameter values. (See step 4 in Figure 7-4.) Ensure the value of CH1~4 info is valid.
6. In the Public Parameters section, set AU CH Info Update to “Update”. (See step 3 in Figure 7-4.)
Note: The maximum bandwidth per operating band should be less than 80MHz and the maximum bandwidth for all
operators should be less than 200 MHz.
Figure 7-4 Setting Channel Properties