User's Manual

CrossFire – A revolution in RF Transport for In Building Wireless
User Manual
44 Revision 1.0.1
Bandwidth
/
RD
UL Center Frequency
/
RD
DL Center Frequency
/
RD
Table 10 AU Sampling Info
Parameter
Description
RD/RW
Over-temperature Threshold
Default value:80℃/ Range: -55~ +125℃
RW
Device Temperature
/
RD
Device Routing Addr
Device routing address
RD
3.7.4. AU Band Config
Table 11 Channel 1~4
CH1 Info Check
Valid: Channel operating normally
Invalid: out of operation
RD
UL Freq_low
Lower limit of uplink frequency
RW
UL Freq_high
Higher limit of uplink frequency
RW
DL Freq_low
/
RW
DL Freq_high
/
RW
Signal1~3 Bandwidth
/
RW
Signal1~3 UL Center Frequency
/
RW
Signal1~3 DL Center Frequency
/
RW
Note: UL Freq_low/high and DL Freq_low/high should agree with the values for the corresponding duplexer.
The values for signal bandwidth and UL/DL center frequency should agree with the operators’ signal.
Table 12 AU Public Parameters
Parameter
Description
RD/RW
AU CH Info Update
Update after channel parameter configuration. Configuration
modification will be effective after update.
RW
Local Signal Bandwidth
Signal bandwidth of local AU
RD
Local Transmission Bandwidth
Transmission bandwidth of local AU
RD
System Signal Bandwidth
Signal bandwidth of all AUs if Slave AU exists
RD
System Transmission Bandwidth
Transmission bandwidth of all AUs if Slave AU exists
RD
Note: See Section 7.2 for details on configuring channel properties.