User's Manual

CrossFire – A revolution in RF Transport for In Building Wireless
User Manual
27 Revision 1.0.1
Figure 2-8 Checking the Wireless Network Status
Figure 2-9 Connecting to WebOMT
2.2.4. USB Access
To set up USB access to the OMT, use the following procedure:
1. Connect a PC to the “Debug” port on the front panel of the device with a USB-to-USB cable.
Note: The USB-to-Ethernet drive should be installed in the connected PC. Contact ZENIC8 if you have any
problems with this.
2. Check the status of the Local Area Connection and confirm the connection was successful.