User's Manual

CrossFire – A revolution in RF Transport for In Building Wireless
User Manual
46 Revision 1.0.1
Parameter
Description
RD/RW
EU CRC Check
To check EU software version
RD
Current RU Upgrade-file name
To check RU software version
RD
HP RU CRC Check
To check RU software version
RD
Table 18 AU Digital Panel Information
Maximum Delay
Maximum delay from AU to the last RU
RD
Table 19 AU: OP Info
OP1~6CPRI Sync Alarm
CPRI SYNC alarm for Port “ OP1~OP6”
RD
OP-AU1 CPRI Sync Alarm
CPRI SYNC alarm for Port “ AU1”
RD
OP-AU2 CPRI Sync Alarm
CPRI SYNC alarm for Port “ AU2”
RD
OP1~6LOS Alarm
Loss of optical signal alarm for Port “OP1~OP6”
RD
OP-AU1 LOS Alarm
Loss of optical signal alarm for Port “AU1”
RD
OP-AU2 LOS Alarm
Loss of optical signal alarm for Port “AU2”
RD
Table 20 AU Advanced Commands
Command
Description
RD/RW
Master / Slave AU Select
Master AU / Slave AU select
RW
Modem Type
Reserve
RD
Backup Battery Switch
/
RW
Hardware Reset
Noted ： Signal interruption during hardware reset
RW
Software Reset
Noted ： Signal is normal during software reset
RW
Wi-Fi Module Reset
/
RW
Initialization/Alarm Report
Initialization: Clear alarms and disable all alarms;
Report Site launch: Report to OMC when new site launches;
RW
Alarm Mode Selection
Normal mode: 3 minutes
Test mode: 1 minute
RW
3.7.8. AU Command
Table 21 AU Factory Parameters
Factory Pattern
To perform Delete all Slave-Devices or Device Initialization functions,
factory authorization is required.
RW
Factory Pattern Password
Reserve
RW