User's Manual
CrossFire – A revolution in RF Transport for In Building Wireless
User Manual
40 Revision 1.0.1
Figure 3-6 Master / Slave AU Selection
After setup is complete, check the device type of the AU.
To query the device type:
1. Log in to the Slave AU WebOMT. (See Section 0 for the procedures to access the OMT.)
2. View the Site Info field. See 3 in Figure 3-6.
3. The device type should be “Slave AU” if the setup was successful.
Note: Please update the day and time after a Slave AU changes to a Master AU.
3.7. OMT Parameters, Alarms and Commands for the AU
See Section 2.3, OMT Display, for information on how to use the WebOMT interface to view and change parameters
and run commands.