User's Manual

CrossFire iDAS – All-Digital Transport System
User Guide
© SUNWAVE SOLUTIONS LIMITED 2017 52 Version 1.0
Figure 8-4 Setting Modules Properties
8.3. Band Configuration for Mapping
NPRU supports a range of 700 ~ 2700 MHz signal for downlink and uplink. And it is not set any band class
as default. Therefore it is most important to set Band Configuration in EU-E OMT to create mapping
between AU and NPRU, which should be done before CrossFire system start to operate.
This section instructs how to set Band Configuration in EU-E OMT for mapping.
1. Get access to OMT on EU-E.
2. Select Band Configuration tab and check the AU Frequencies Information and AU Carrier
Configuration for choosing appropriate modules to map. (See Figure 8-5)
3. Set RF Module Mapping Configuration: (See Figure 8-6)
a. Select 10GE Port which is physically used for connection to NPRU in GE Port.
b. Set appropriate mapping for each NPRU Module.
c. Select GE Port and all NPRU Module checkbox and click Set in pop-up window to save the
configuration.
d. Click Update button to validate the configuration in system.
4. Click Query all in pop-up window to query NPRU RF Module Mapping Info to check if the mapping
configuration is validated. (See Figure 8-7)