User's Manual

CrossFire iDAS – All-Digital Transport System
User Guide
© SUNWAVE SOLUTIONS LIMITED 2017 36 Version 1.0
Table 5-7 10G-PHY
5.4.4. EU-E Engineering Information in Maintenance
Parameter
Description
RD/RW
Data Update Time
Last update time
RD
ARM CRC Check
To check ARM software version
RD
FPGA CRC Check
To check FPGA software version
RD
EU CRC Check
To check EU software version
RD
Table 5-8 Engineering Info
Parameter
Description
RD/RW
10GE1~12 CPRI Sync Alarm
CPRI SYNC Alarm of Port 10GE1~12
RD
OP-slave CPRI Sync Alarm
CPRI SYNC Alarm of Port SLAVE
RD
OP-master CPRI Sync Alarm
CPRI SYNC Alarm of Port MASTER
RD
OP-slave LOS Alarm
Loss of optical signal Alarm of Port SLAVE
RD
OP-master LOS Alarm
Loss of optical signal Alarm of Port MASTER
RD
Table 5-9 OP Info
Command
Description
RD/RW
Hardware Reset
Note: Signal interruption during hardware reset
RW
Software Reset
Note: Signal is normal during software reset
RW
Alarm Initialization
Initialization: Clear alarms and disable all alarms;
Report Site launch: Report to OMC when new site launches;
RW
Alarm Mode Selection
Normal mode: 3 minutes
Test mode: 1 minute
RW
Table 5-10 Advanced Commands
5.4.5. EU-E Factory Command
Parameter
Description
RD/RW
Factory Mode
Access to Factory Mode with authority
RW
Factory Mode Password
Reserve
RW
Table 5-11 Factory Parameters
Parameter
Description
RD/RW
10GE1~12 Information
/
RD
Firmware Version
/
RD
Link Mode
/
RD
Auto Negotiation
/
RD
Speed
/
RD
Duplex
/
RD
CHA SNR/mini SNR operating margin
/
RD
CHB SNR/mini SNR operating margin
/
RD
CHC SNR/mini SNR operating margin
/
RD
CHD SNR/mini SNR operating margin
/
RD
BER counter
/
RD