User's Manual

CrossFire iDAS – All-Digital Transport System
User Guide
© SUNWAVE SOLUTIONS LIMITED 2017 34 Version 1.0
SN
Interface Name
Description
1
GE1~12
Wi-Fi signals or S1 signals input
2
SLAVE
Connection to Master AU/EU-E at the next higher level
3
MASTER
Connection to next lower level EU-E
4
10GE1~12
Connection to NPRU through CAT-6A STP
5
CONSOLE
Connection to a PC through CAT-5 for local and remote monitor
6
AP
Connection to WLAN Network Adapter for wireless access to OMT
7
STATUS
Indicates device operating status
8
PWR
Electrical Power Line Interface
Table 5-1 EU-E Front Panel Interfaces
5.3. Indicator Description
In Figure 5-2, #7 points to the STATUS indicator in the front panel of the AU. Table 5-2 lists the indicator’s
behaviors and their meaning.
STATUS
Description
Flashes green
Device runs normally without alarm
Turns green and stays lit
Software has crashed, but it can reboot automatically in 3mins
Flashes red
Device runs normally but alarm arise
Turns red and stays lit
Software has crashed, but it can reboot automatically in 3mins
Flashes Orange
Software is upgrading
Turns orange and stays lit
Device is starting
Table 5-2 STATUS Indicator
5.4. OMT Parameters, Alarms and Commands for the EU-E
See Section 3.3, OMT Display, for information on how to use the WebOMT interface to view and change
parameters and run commands.
Note: The input fields cannot contain the following special characters: %, &, ‘, “, \
5.4.1. EU-E LAN Connectivity
Parameter
Description
RD/RW
Vendor
Name to distinguish from different manufacturers
RD
Product Model
/
RD
Serial Number
/
RD
Software Version
/
RD
FPGA Version
/
RD
Device ID
Number to distinguish the subsets in the same site
RW
Device Sub ID
/
RW
Device Location
/
RW
Site ID
The unique identification number of site in the system assigned
by Master AU
RW
Device Temperature
/
RD