User's Manual

CrossFire iDAS – All-Digital Transport System
User Guide
© SUNWAVE SOLUTIONS LIMITED 2017 30 Version 1.0
UL Freq_high
Higher limit of uplink frequency
RW
DL Freq_low
/
RW
DL Freq_high
/
RW
Digital Signal Bandwidth
/
RW
Signal UL Centre Freq
/
RW
Signal DL Centre Freq
/
RW
Table 4-13 Module 1~4 and Virtual Module
Note: UL Freq_low/high and DL Freq_low/high value should be conform to the corresponding duplexer.
The values for signal bandwidth and UL/DL center frequency should be conform to the operators’ signal.
Table 4-14 General
Note: See Section 8.2 for details about Band Properties Configuration.
Table 4-15 System Delay
4.7.5. AU Combiner
Parameter
Description
RD/RW
Combiner Att Control Mode
Automatic or Manual
RW
Adjust Interval
Test(60 Sec), 6 Hour, 12 Hour or 24 Hour
RW
Table 4-16 General
Parameter
Description
RD/RW
UL Freq Low/High
Module UL Frequency information
RD
DL Freq Low/High
Module DL Frequency information
RD
Port 1~4 Input Power Value
Input power query
RD
Port 1~4 Attenuation Value
Input field for attenuation
RW
Port 1~4 Power Offset Value
Input field for power offset
RW
Port 1~4 Operator
Input field for Operator information
RW
Table 4-17 AU Module 1~4
Parameter
Description
RD/RW
AU CH Info Update
Update after channel parameter configuration. Configuration
modification will be effective after update.
RW
System Transmission Bandwidth
Transmission bandwidth of all AUs if Slave AU exists
RD
Parameter
Description
RD/RW
Delay Adjustment Type
Automatic or Manual
RW
Max Delay Measured Value
/
RD
Max Delay Adjust Value
/
RD
Manual Delay Activation
/
RW