User's Manual

CrossFire iDAS – All-Digital Transport System
User Guide
© SUNWAVE SOLUTIONS LIMITED 2017 27 Version 1.0
Figure 4-8 Site Info
Note: Please update the day and time in LAN Connectivity after a Slave AU changes to a Master AU.
4.7. OMT Parameters, Alarms and Commands for the AU
4.7.1. LAN Connectivity
Table 4-5, Table 4-6 and Table 4-7 show General, IP Settings and FTP Settings. Respectively, these
parameters are displayed in LAN Connectivity in WebOMT.
Note: The input fields cannot contain the following special characters: %, &, ‘, “, \. Device ID cannot be set
to FFFFFFFF in order to avoid the NPRU synchronized failure.
Parameter
Description
RD/RW
Vendor
Name to distinguish different manufacturers
RD
Product Model
/
RD
Serial Number
/
RD
Software Version
/
RD
FPGA Version
/
RD
Device ID
Number assigned by the system to distinguish subsets in the
same site
RW
Device Sub ID
/
RW
Device Location
/
RW
Site ID
The unique identification number of the site in the system
RW
Table 4-5 General
Parameter
Description
RD/RW
Protocol
UDP or SNMP
RW
NMS IP Addr
IP address of Monitor Center
RW
NMS Port
Port Number of Monitor Center
RW
Trap IP Addr
Trap IP of SNMP Monitor
Trap Port
Port Number of SNMP Center
RW
Device IP Addr
Default IP Address — 10.7.3.200
RW
Subnet Mask
Default Subnet Mask— 255.0.0.0
RW