User's Manual

CrossFire iDAS – All-Digital Transport System
User Guide
© SUNWAVE SOLUTIONS LIMITED 2017 22 Version 1.0
Figure 3-15 Displaying the System Topology
Device icons in the topology have two colors —green and red:
Green icon indicates this device is connected.
Red icon indicates this device was once connected but is currently disconnected.
When a red icon shows up, check whether this device exists or not. If the device does not exist, delete
device on the topology page by right-clicking the device icon. And there is a Delete All Slave-Devices
button at up right of topology for deleting all slave devices in topology.
Note: deleting one device or all slave devices should be under Factory Mode. Get into Factory Mode
through Maintenance -> Factory Command -> Factory Parameter
This symbol indicates the devices with alarms.
If PC is solo connected to slave devices, the topology in WebOMT will be blank.