Installation Guide

15 of 36
Install CableStrap
STEP 4.5
Measure the edge of the Heated Area where
CableStrap will be installed.
Double-sided tape
STEP 4.6
Cut the CableStrap to length using
metal shears.
STEP 4.7
Secure the strap to the floor. Depending on
the floor type, different methods may be used.
Concrete, self-level, or similar: Double-
sided tape (if included with your cable), hot
glue, or strong spray adhesive may be used
if the floor is well cleaned and the strap is
wiped free of any oils. However, it is highly
recommended to also place screws at each
end of the strap, and every 4 to 5 feet, to
ensure it does not come loose. If using a
strong spray adhesive, apply to both the
back of the strap and the floor where it will
be placed, and carefully follow all spray
manufacturer’s instructions and cautions.
Cut another piece of strap for the other end
of the area and secure to the floor.
Hot glue
Spray adhesive
OR
OR
OR
Plywood, cement board, or similar:
Galvanized nails or screws may be used to
secure the strap every 6" to 10".
Galvanized nails
Screws