Operation Manual

37
During the process of cooling some water will be extracted from the air into the unit. If the reservoir is full, both
the compressor and motor will stop and the units would buzz (you can press any button to stop the buzz), only the
fan runs to circulate the air. The W.F. indicator will flash to show you.
To make the cooling work again, please empty the water by one of the following ways:
1. Turn off the air conditioner and avoid
moving it while full.
2. Position a container (a water tray e.g.)
underneath the drain hole.
3. Remove the drain knob & rubber plug from
the drain hole and allow the water to drain
out.
4. When the container is almost full, replace
the rubber plug in the drain hole to stop the
water and empty the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the
drain knob firmly.
7. Switch on the unit – the full water or
compressor indicator should not be flashing.
2
By water tube (continuous drainage)
1. Remove the drain knob and rubber plug
and retain for future use.
2. Connect the drain tube supplied to the
water outlet as shown and locate the other
end into a drain.
3. The drain tube may be extended by adding
an extension tube and using a suitable
connector.
NOTE: The drain must be at or below the outlet
level. Flashing comp/”full water” indicator will
not function in this mode of drainage. If you
want to extend the water tube connect it with
another tube (OD:18mm)
MAINTENANCE