User Manual

Cut-Out Line Drawing
Front Control Panel------------- 24”
Firebox Depth-------------------- 22-1/4”
Cut-Out Depth------------------- 22-1/2”
Product Depth------------------- 26-1/2”
Firebox Width-------------------- 22-1/4”
Cut-Out Width------------------- 22-3/4”
Pot Filler Notch-Out
Cut-Out Box Width------------- 1-1/2”
Cut-Out Box Depth------------- 7/8”
Cut-Out Edge to Pipe Center- 3/4”
Cut-Out Side Edge to Pipe Center- 7/8”
Cut-Out Height Details
Cut-Out Height----------------- 10”
The Cut-Out Height of 10” is measured
from the top of counter edge, this
allows a minimum of ¾” opening below
drip-pan for greater air/gas ventilation.
Product Size
Overall Width-------------------- 24"
Overall Height------------------- 18-1/2"
Overall Depth-------------------- 26-1/2"
Control Panel Height----------- 10-1/2"
Firebox Size
Box Width------------------------ 22-1/4”
Box Depth------------------------ 22-1/4”
Box Height----------------------- 9”
Supporting Lip Overhang----- 1”
Cut-Out Details
It is always best to first have the Burner On-Site, if you cannot make sure to follow all Cut-Out instructions
exactly as shown.
 The Burner is SELF-RIMMING, meaning the lip of grill rests on top of the counter edge around the
cut-out with the front of grill which is Free Hanging from countertop. Because of this, there is No
Need for any Trim-Kit like with many other grills in the market.
 If you have a Counter Overhang, be sure to Notch Out a Cut-Out on the Left & Right side of Burner
Cut-out so that Burner will sit Flush against the island wall.
BURNER INSTALLATION
–
CUT
-
OUT DETAIL
PAGE 4
Technical Measurements
Cut-Out Measurements