How to Guide

GRILL STARTUP –Lighting the Burner

Lighting Instructions

NOTE: To light the Burner with a gas lighter, make sure the Burner has

been leak tested and burners be properly located. Insert long-necked gas

lighter through the cooking grid placing near a burner side. Turn the burner

knob on to “HIGH” setting to release gas. Turn on the button on gas

lighter, burner should light immediately. Adjust burners to desired cooking

temperature.

Remove Cover

Ensure Burner Control Knobs

In the “OFF” position,

Turn on the gas supply valve

1. P

ush the burner knob in and slowly

rotate counter-clockwise to the high

position. Listen for the sound of the gas

through the Brass-Burner

2. You will hear a loud click as the Valves

Piezo Ignition produces a spark. If the

burner does not light on the first try,

repeat immediately.

If the burner does not light in 5

seconds then wait five minutes until the

gas clears before attempting to light it

again. Repeat the procedure or try the

manual lighting procedure below.

Tip:

 It is normal to hear a popping

sound when the burners are

turned off.

 Turn gas off by rotating back to

OFF position

 Always perform a Leak Test

before each use. If there is a Gas

Leak the Air will have a Pungent

Odor.

WARNING: When Lighting the Burner. DO NOT RELEASE KNOB, GAS WILL CONTINUE TO FLOW.