User Manual
5. Silicone Seal
It is recommended to seal all three outer
edges using Clear-Silicone which will
prevent any rain water or insects from
getting down into island enclosure and
or water buildup in the drip pan of grill.
GRILL
INSTALLATION
–
STEP BY STEP GUIDE
PAGE 4
6
. Allow for Ventilation
The grill is engineered with special vents
on the back of unit, which allow proper
airflow out of the back of grill. Push grill
all the way into cut-out, there is a
stopper flange just behind the back vent
which will insure the area stays clear for
adequate air flow to the bottom burners.
The Control Panel should be flush
against the front of your island finish
wall, see Cut-Out Details for Notch-Out
Instructions.
4. Slide Grill in Place
The grill is specially designed with an
internal built in hanger lip located at the
Right, Left and Back sides. The grill lip
allows it to hang by the three supported
edges on the right, left and back. The
front control panel requires no
supporting edge, it is designed to hang
down the front of your cut-out.