User Manual
Q. LED Light is not functioning
A. Likely your LED Light has malfunctioned due to the grill being overheated, or there may be a loose wire on
the internal control circuit board. You can access these components by sliding the grill out from your island
approx. 6 Inches, there are 4 screws on either side holding the front control panel to grill body, and 2 Alan
Wrench Screws on the inside facing towards front panel, you will see 2 Holes. Also unclip the back of grill right
side gas manifold to side of grill. There is an inside box containing the LED light strip you will now have access
to. You can then easily unplug and replace LED light with new one or check for other loose connections.
Q. The Gas Burners flame is very Low
A. If your grill is using a 25 Pound Portable tank and is directly connected to grill with no other appliance, you
may have a Spider Web or other clog in the gas Pipe. If your grill is connected to a Side Yard 500 Gallon Tank,
there may be an issue with the Regulator – either it is a Low-Pressure Regulator being used, or not enough gas
pressure is being allowed to the grill. If you have any T-Connections in gas line going to other outdoor
Appliances like a Fireplace or Side Burner, this can also greatly diminish gas flow.
GRILL START
-
UP
-
TROUBLE SHOOTING
PAGE 15