Spec Sheet

GRILL PLACMENT & INSTALL
IMPORTANT! REFER TO PRODUCT MANUAL FOR A COMPLETE
DESCRIPTION OF INSTALLATION, PLACEMENT AND CUT-OUT.
6. Allow for Ventilation
The Grill is engineered with special vents at the back
of unit, which allow proper airflow into the underside
firebox and IR-Burners. It is important to open this
vent specifically when using the Griddle, Charcoal Tray
or Searing Grate to allow proper air-flow to burners
and venting excess heat
4. Slide Grill in Place
The Grill is designed with an internal built in hanger
flange located at the Right, Left and Back sides. The
grill flange allows it to hang by the three supported
edges on the right, left and back. The front control
panel requires no supporting edge; it is designed to
hang down the front of your cut-out. Never build any
enclosure below the grill preventing the grill from
properly venting heat, or gas.
2. Elect. Connection
Locate the Light Button on Left side of grill control
panel. The Transformer's electrical connection to
grill is located at the back left under-side. The
connection clips together to form a secure
connection. Double check that all wires are tightly
pushed into plug sockets, so all wires make proper
connections. You can tuck wire into body of grill or
island frame, so it's up and out of the way.
3. Gas Line Connection
See the BACK-RIGHT UNDER-SIDE – This is where
the Gas Line will connect to the Grill. Grill is shipped
as either LP or NG gas type. Recommendation to
have an 18” hose to allow grill to be pulled out if
necessary. For LP & NG Gas Conversion help call 888
-934-9449 for technical support.
1. Mount Transformer
Using metal screws and attach the transformer to the
back inner wall of your island’s cabinet wall,
somewhere near the already installed GFCI electrical
outlet. When you plug the transformer in, double
check the GFCI breaker switch, that the outlet has
power.
5. Clear Silicone Seal
It is recommended to seal all three outer edges using
Clear-Silicone which will prevent any rain water or
insects from getting down into island enclosure and or
water buildup in the drip pan of grill.
PAGE 2
OPEN VENT FOR INCREASED
AIR-FLOW TO BURNER