User's Manual

13.AboutFirmware


Firmware (ROM Package) contained in the Tablet PC provides the control program for the device, and it is offered by the original
manufacturer.

ReloadingfirmwareistorebuildsystemintotheTabletPC,anditisthefinalsolutiontoserioussystemproblems.Afterreloadingfirmware,
alluser’sdata
willbecleaned.Forcommonbreakdown,userscanjustrestarttheTabletPC,orrunfactoryreset.Ifsystemcrashesappear
continuouslyevenusershaverunfactoryreset,theycanreloadfirmwareunderprofessionalguidance.

ThefirmwarepreloadedintheTabletPCisastableversionforthedevice,please
donotreloadfirmwareunlessitisabsolutelynecessary.
WeDO NOTsuggestusersreloadingfirmwarewithout professionalguidance, andwe shall benotresponsible forTabletPC’sbreakdown
causedbyusers’improperoperation.

Forfurtherinformationoffirmware,pleasecontactwiththemanufacturerofthedevice.
FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between theequipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Mobile device:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
The final terminal equipment this tablet will be used in is a resistance welder.
There should be no conditions or cautions thatshould come up when the tablet is installed in the final unit.
The tablet is enclosed and protected.
This product is used in embedded fixed terminal equipment and is not sold as a stand-alone product