Spec Sheet

SAC30APC SETUP INSTRUCTIONS 2

Packaged with the back panel item no.

SCC21SPE there is a cross-beam support with

counter rail attached. This support beam

supports the counter front. Using included

screws mount this panel at the Left & Right

Side as shown in figure C to left.

IMPORTANT! If you are planning to remove Counter Rails for Full

Bullnose or Watefall Counter Edge, you MUST remove all Counter Rails BEFORE

cabinets are connected to each other and BEFORE counter is installed.

IMPORTANT! If you are placing any appliance which product height is

higher than 34-1/2", you can either increase the height of Peg-Leg up to an

additional 1-1/2" higher, or simply do not install the Support Arm giving you an

immediate 1" additional height clearance.

WATERFALL EDGE EXAMPLE

SCC21SPE

SCC4SPEL

SCC4SPER

SCC4SPEL

SCC4SPER

If you intend to have your counter to include a

type of Full Bullnose or Waterfall edge, you can

remove the counter rail allowing the counters

edge to be near to the cabinet instead of

extending beyond the front panel wall.