Installation and Operation Manual

Form #43219020
Sept 2012
6) SG SERIES DIMENSIONS
7) HANGING
The heater can be mounted with the reflector horizontal or angled up to 35º from horizontal. When the heater is to be
angle mounted, make sure the gas manifold assembly is on the lower side of the heater. Coil chains (No. 2 or larger) or
rigid supports may be used to mount the heater, which must be suspended from a permanent structure with adequate
load capacity. The gas manifold assembly tube must be level, and for angled mounting, it must be at the LOWER end of
the heater. All “S” hooks and eyebolts must be manually crimped closed by the installer.
8) GAS CONNECTIONS AND REGULATION
7