Installation and Operating Guide

-9-

1. STOP! Read the safety information above.

2. Make sure manual shutoff valve is fully open.

3. Turn thermostat control knob clockwise ( )

to the “OFF” position.

4. Wait ten (10) minutes to clear any gas.Then smell

for gas, Including near the floor. If you smell gas,STOP!

Follow “B” in the safety information above. If you don´t

smell gas, go to the next step.

5. Find pilot attached to the main burner which is located

at bottom of combustion chamber.

6. Turn knob on gas control counterclockwise ( )

to “Pilot” position.

Pilot

Burner

Pilot

Burner

7. Depress and hold down the thermostat control knob.

While holding the control knob down, push the

piezo ignitor button repeatedly to light the pilot.

Continue to hold the control knob in for about 30 seconds

after the pilot is lit.Release knob and it will pop back up.

Pilot should remain Iit. If it goes out repeat steps 3 through 7.

If knob does not pop up when released,stop and

inmediately call your service technician or gas supplier.

If the pilot will not stay lit after several tries, turn the gas

control knob to the “OFF” position and call your service

technician or gas supplier.

8. Attention! Gas control has an INTERLOCK device.

When the pilot is initially lit and the safety magnet in energized

( pilot stays “ON”) the INTERLOCK latching device becomes

operative.

If the gas control is turned to the “OFF” position or gas flow to

the appliance is shut off, the pilot cannot be relighted until the

safety magnet is de-energized (approximately 60 seconds ).

There will be an audible “click” when the safety magnet in

the gas control is de-energized.

Pilot can now be relighted. Repeat steps 3 through 7.

9. Turn gas control Knob counterclockwise ( ) to the

desired heating level from “LO” to “HI”.

OFFHI