Instructions / Assembly

13
Typical, Single Panel, Single Span Mid-Field Detail
Figure 25
C
2
8
4
1
4
D
4
5
B
6
n Wind/Rain
Direction
Mai
Slope Direction
A
C
2
4
1
4
E
4
5
10
B
6
n Wind/Rain
Direction
Mai
Slope Direction
A
8
1
8
7
E
10
3
8
9
1
Typical Bottom End
SunSky Detail (with or without gutter)
Figure 26
Figure 27
Figure 28
M. Options for Installation:
1. Single width, single span installation (on 2 edge
support purlins), integrated and surrounded by
matching metal panels, overlapped on top, overlapping
and supported on both sides and at the bottom. This
dictates that the top metal panel is also installed with its
edge corrugations overlapping at both sides, up to the
roof edge or ridge.
Legend
Connections
A Right side-lap: metal panel overlaps SunSky panel
B Left side-lap: SunSky panel overlaps metal panel
C Top end-lap: top metal panel laps over top edge
of SunSky panel
D Bottom end-lap: bottom edge of SunSky panel laps
over top edge of metal panel
E Bottom edge detail: SunSky panel at the bottom
edge of a roof, with or without a gutter
Components
1 Representative SunSky panel
2 Metal panel
3 SunSky valley fastener, with Palram
3/4" special washer gasket
4 Typical sheet-metal crest or valley
fastener with 3/4" washer & gasket
5 SunSky crest (side-lap) fastener with
Palram 3/4" special washer & gasket
6 SunSky side-lap stitching fastener
7 Foam closure (underside shape)
8 Supporting purlin
9 Main supporting truss / beam
10 Optional drainage gutter