Instructions / Assembly

12
1
6
2
5
4
1
2
4
5
6
1
3
5
6
4
1
4
3
5
6
SunSky Ridge Cap Fastening
Figure 23a
Sheet-Metal
Ridge Cap Fastening
Figure 24a
Sheet-Metal Ridge Cap Fastening
& Top Partial Section
Figure 24b
Important notes about installation of SunSky Ridge Caps
1. Do not over tighten screws when installing. If ridge cap deforms, screws are too tight.
2. Use recommended fasteners as shown on page 8, Table 2.
3. When installing clear ridge caps on wood purlins, purlins should be painted with white acrylic-based paint prior to
installation. This will help prevent overheating and possible charring of the purlins.
Legend
1 Representative SunSky panel
2 SunSky Universal Ridge Cap
3 Sheet-metal universal ridge cap (typical)
4 Crest fastener (side-lap) with Palram 3/4" special washer & gasket
5 Shaped Foam Closure (fits topside of panel)
6 Supporting purlin
SunSky Ridge Cap Fastening
& Top Partial Section
Figure 23b