Installation Guide

How to Install Micro Micro Drippers with Micro Tube
This kit includes both Antelco Shrubblers & Micro Tube. To install them:
1) At the nearest location on your poly tube to where you want to place your
dripper, use the included Micro Punch Tool to punch a hole in the side of your
poly tube.
2) Pick up one Antelco Shrubbler, you’ll see a Micro joiner attaches to its side.
Tear it off & push it into the hole in your Poly Tube. It shouldn’t come out.
3) Take your Micro Tube and cut it to the length you need to reach the position
your dripper will be placed.
4) Push one end of the Micro Tube into the Joiner in the Poly Pipe, and the other
into your Antelco Shrubbler. (Wait to attach your Shrubblers until after you’ve
flushed the system) Then spike the dripper in place.
3) Program Your Timer
This Kit includes a Rainbird 1ZEHTMR Tap Timer, learn how to program it here:
• Watch YouTube Video
• Read Product Manual
4) Flush & Adjust The System
Although we have no doubt you worked as cleanly as possible, you want to make sure
there’s no dirt or grit in the lines from installation that will block the system up on it’s
first cycle. So just:
1) Make sure all of your shrubblers aren’t yet pushed on yet on,
2) Give the system a manual cycle for a minute or 2,
3) Push on your Drippers, adjust so their flow is just right & enjoy your new micro
dripper system!