Installation Guide

ManualsBrandssunshower ManualsRotatorsunshower Lawn Pop-Up Rotator Irrigation DIY Kit

Lawn Pop-Up Rotator Irrigation DIY Kit

(inc. Rainbird Timer)

Installation Guide

Congratulations! Your garden is about to benefit from some of your finest work, with

the help of this DIY Irrigation Kit. While gardens do come in all shapes and sizes,

we’ve done our best to put together this kit to suit your typical medium sized lawns.

And even if it doesn’t quite include everything for your place, for instance you need an

extra fitting here or there, it’s still a great way to get started with your own irrigation

project.

Kit includes:

• 1 x Rainbird 1ZEHTMR Digital Tap Controller

• 2 x AA Batteries

• 1 x 19mm x 20mm Nut & Tail

• 2 x 25m 19mm Poly

• 4 x 19mm Elbow

• 2 x 19mm Tee

• 2 x 19mm x 15mm M.I. Side Outlet Elbows

• 2 x 19mm x 15mm M.I. Tees

• 2 x 19mm x 15mm M.I. Elbows

• 25 x 19mm Ratchet Clamps

• 6 x 100mm Hunter Pro-Spray Pop-Ups

• 6 x MP1000 90-210 Nozzles

• 1 x Teflon Tape

• 1 x MP Tool

Tools you’ll need:

• Shovel

• Pipe Cutters (or Secateurs)

• Multi-Grips (to tighten the Ratchet Clamps)

Summary of content (5 pages)

PAGE 1
Lawn Pop-Up Rotator Irrigation DIY Kit (inc. Rainbird Timer) Installation Guide Congratulations! Your garden is about to benefit from some of your finest work, with the help of this DIY Irrigation Kit. While gardens do come in all shapes and sizes, we’ve done our best to put together this kit to suit your typical medium sized lawns.
PAGE 2
Installation Steps 1. 2. 3. 4. Identify a preferred layout & dig trenches (or scrape away mulch) Roll out pipe & install parts Program your timer Flush the system 1) Identify a preferred layout & dig trenches How to work out your ideal sprinkler layout Rotator Spray Heads fitted into Pop-Ups (like the ones included in this kit) provide the most even coverage when positioned to spray all the way to the base of the next one, so you want considerable overlap.
PAGE 3
How to plan trenches Always start from your water source (usually a garden tap) & identify a path that runs to the base of where each sprinkler will go. The Sprinklers will screw directly into the pipe with the help of a Poly M.I. Tee (inline) or Poly M.I. Elbow (at an end point). Your goal here should be to minimise the distance the water needs to travel to get to each spray.
PAGE 4
2) Roll out pipe & install parts As you roll out the pipe & connect each piece, always start from the timer, it will make your life a whole lot easier. How to connect the timer Connecting your Rainbird 1ZEHTMR Tap Computer is easy: 1. Pull the battery case out of the back of the timer & insert the included AA batteries. 2. Screw the timer directly onto the tap. (the timer screws onto a standard 20mm tap, if you have a non-standard 25mm tap, you may need one of these) 3.
PAGE 5
3) Program Your Timer This Kit includes a Rainbird 1ZEHTMR Tap Timer, learn how to program it here: • • Watch YouTube Video Read Product Manual 4) Flush & Adjust The System Although we have no doubt you worked as cleanly as possible, you still want to make sure there’s no dirt or grit in the lines from installation that will block the system up on it’s first cycle.