Replacement Part List

5.Mounting the hedge trimmer

Place the hedge trimmer precisely as shown in below figure on the connecting rod.

Adjust the slope by unlocking the lock.

The hedge trimmer can be tilted from 0 ° to 90 °.

6. Fitting the cutter bar and the chaine

Remove the chain wheel cover (Item J) by undoing the fastening nut (Item I). Lay the chain (ItemF) as

shown into the groove which runs around the cutter bar (Item E).

Note the alignment of the chain teeth. Insert the cutter bar as shown in below figure into the mount at the

gear unit.

Place the chain round the chain wheel (Item H). Make sure that the teeth of the chain engage securely in

the chain wheel. The cutter bar must be hooked into the chain tensioning bolt (Item G).

Fit the chain wheel cover

7 Tensioning the chain

Important! Always pull out the spark boot plug before performing any checks or adjustments.

Undo the fastening screw (Item I) of the chain wheel cover by a few turns.

Adjust the chain tension with the chain tensioning screw (Item K). Turning the screw clockwise

increases the chain tension, turning it counterclockwise decreases the chain tension. The chain is correctly

tensioned if it can be raised by around 2 mm in the middle of the cutter bar.

Tighten the fixing screw of the chain wheel cover.

Important! All the chain links must lie properly in the guide groove of the cutter bar.

I J

2 mm

Important! Do not fully tighten the fastening screw until after you have adjusted the chain tension.