Replacement Part List

3.1 Fitting the guard for curved shaft grass deflector:

-Remove the guard plug (1) from the end of the bottom part of the rod (2).

Secure the guard (3) to the support (4) using the supplied bolts (5)

3.2 Fitting the guard for straight shaft grass deflector

Fix the transmission with hex key and wrench enclosed as standard

accessories for tightening

the nuts with the safe guard.

-The guard is fixed to the angle transmission by two screws

Warning! Use only original manufacturer's replacement parts, accessories and

attachments. Failure to do so can cause poor performance, possible injury and may void

your warranty. Never use the machine without the guard assembled!

4. Assembly and disassembly of the cutting head

4.1 Assembly and disassembly of the cutting head

a) Assembly

Block rotation of the shaft (1) with a proper wrench.

Fit the cutting line head (2) screwing it clockwise.

b) Disassembly

Block rotation of the shaft (1) with a proper wrench.

Remove the cutting line head (2) unscrewing it anticlockwise.

4.2 Assembly and disassembly of the cutting head

a) Release the nut. Line up the two holes of flange and shield, use one screw driver to hold the

flange as below and turn the socket wrench clockwise, the nut will be released.

b) Fit the Nylon cutting head. Remove another shield after release the nut. Still hold the flange,

take the Nylon cutting head on the shaft and rotate counter-clockwise, the Nylon cutting head is

fitted.

FIG 3.1

FIG 4.1