Replacement Part List

Mowing with grass trimmer

Mowing with brush cutter and hedge trimmer

The design of the petrol brush cutter allows for operation only at the right side of the user's body.

Keep the petrol brush cutter firmly with both hands on the handles.

Always make sure that the cutting tool continues to rotate briefly after the throttle has been

released.

Always so that the cutting tool no longer turns in a proper engine idle not press down the throttle.

Always work with high speed so you have the best cutting results.

Poke when working on a stone or a tree, turn off the engine and remove the spark plug then

examine the petrol brush cutter for damage.

Caution: Always be extra careful when working in difficult terrain and slopes. Cut tall grass

gradually soas not to overload the unit.

Always wear safety glasses and hearing protection and a safety helmet.

Use the plastic line cassette for a clean cut also atuneven edges, fencing posts, and trees.

Carefully advance the trimming line to an obstacle, and use the tip of the line to cut around the

obstacle.

When the trimming line comes into contact with stones, trees, and walls, the line wears out or

breaks off ahead of time.

Swing the petrol cutting blade like a normal scythe horizontally from right to left and back again.

You define the cutting height depending on how high you are holding the tool.

Never replace the nylon line with a metal wire.

RISK OF INJURIES

Use the cutting blade to comb through brushwood, rank growth, young tree populations (trunk

diameter of maximum 2 cm), and high grass.

While using metal cutting tools, there is generally a risk of recoil, when the tool hits a solid obstacle

(stones, trees, branches, etc.). Thereby, the tool is hurled backwards against the rotating direction.

To cut rank growth and brushwood, you “immerse” the cutting blade from the top.

CAUTION: Be especially careful, when using this working technique, because the further away the

cutting tool is from the ground, the higher is the risk that objects to be cut and particles will be

hurled sideways.

CAUTION: Incorrect use and misuse can damage the bush cutter and cause severe injuries

because of pieces hurled away.

To minimize the risk of accidents by use of the cutting blade, take note of following points:

Never cut shrubbery or wood whose diameter is larger than 2 cm.

Avoid contact with metal bodies, stones, etc.

Periodically check the cutting blade for damages. Never continue to use a damaged cutting blade.

When the cutting blade becomes apparently blunt, it must be sharpened according to instructions.

When the cutting blade is apparently out of balance, it must be replaced.

Automatic thread trimming

The petrol cutting blade is delivered with a filled line cassette.This line will wear out during work. To

feed new line, forcefully press the head of the line cassette onto the ground while the engine is

running at working speed. The line is automatically fed due to centrifugal force.The knife at the line

guard will shorten the trimming line to the correct length. Run the trim line approach cautiously to

an obstacle and cut with the tip of the line around the obstacle.