Instructions / Assembly

palram.com/us 17
• Installing End Prole Bases with UNCUT Roof Panels
IF YOU HAVE ALREADY INSTALLED CUT ROOF PANELS, SKIP TO PAGE 19.
END PROFILE BASES HAVE A DIFFERENT ORIENTATION WHEN USED WITH
UNCUT ROOF PANELS.
1
2
• Be sure the correct edge of the End Prole Base
is facing inward toward the roof.
• Center the prole in the middle of the rafter.
• Using the spacer bar at every hole, fasten
screws through the pre-drilled holes along the
rst End Prole Base.
• Be sure the correct edge of the End Prole Base
is facing inward toward the roof.
• Center the prole in the middle of the rafter.
• Using the spacer bar at every hole, fasten
screws through the pre-drilled holes along the
second End Prole Base.
Fasten the rst End Prole Base to the left edge of the roof.
Fasten the second End Prole Base to the right edge of the roof.
INSTALLATION
NOTE: PROFILE
CLOSURE NOT
SHOWN IN
DRAWING
NOTE: PROFILE
CLOSURE NOT
SHOWN IN
DRAWING
CORRECT PROFILE ORIENTATION
CORRECT PROFILE ORIENTATION