Instructions / Assembly

8 Palram Americas
• Drilling Holes in the Proles
• Adding Prole Closures
Measure, mark and pre-drill 1/4" screw holes in each End Prole Base and Inner Prole Base.
• Follow the hole spacing guidelines below for rafter or purlin installation to match your roof support structure.
• Make sure all holes are centered along the notch in the middle of each Prole channel.
Fasten a Prole Closure to the TOP and BOTTOM end of every End Prole Base
and Inner Prole Base.
• The Prole Closure will prevent the Roof Panel from sliding o when the Roof Panel is being installed.
5
6
24" max
24" max
24" max
2"
2"
2" min
Overhang
PROFILE
RAFTER
WALL
RAFTER INSTALLATION PURLIN INSTALLATION
Measure distance
between purlins
center to center
PROFILE
PURLIN
WALL
PURLIN
PURLIN
End Prole Base
Inner Prole Base
Before drilling holes, place the End Prole Base over a strip of wood.
This will protect the end of the drill bit as it penetrates the End Prole Base.
End Prole Closure
Inner Prole Closure
= HOLES/FASTENING POINTS
BEFORE INSTALLATION