Instruction Manual

Operation

MODE button

Selects the appropriate operating mode.

Each time you press the button, a mode

is selected in a sequence that goes from

COOL, FAN and DRY .The mode indicator

light illuminates under the different mode

setting.

NOTE: On above modes, the unit operates

the fan speed automatically. You can

set fan speed only by the remote controller

on COOL and FAN modes.

Used to adjust (increasing/decreasing)

temperature settings in 1°C/1°F

increments in a range of 17°C/62°F to

30°C/86°F.

NOTE: The control is capable of displaying

temperature in degrees Fahrenheit or

degrees Celsius. To convert from one to

the other, press and hold the Up and Down

buttons at the same time for 3 seconds.

Power button

Power switch on/off.

Power

indicator light

Timer mode indicator

light (set only by

remote controller)

Up (+) and Down (-) buttons

LED display

Shows the set temperature while on cool mode. While on DRY

and FAN modes, it shows the room temperature.

Shows Error codes:

E1-Room temperature sensor error.

E2-Evaporator temperature sensor error.

E4-Display panel communication error.

Shows protection code:

P1-Bottom tray is full--Connect the drain hose and drain the

collected water away.If protection repeats,call for service.

Note: When one of the above malfunctions occurs, turn off the

unit, and check for any obstructions. Restart the unit, if the

malfunction is still present, turn off the unit and unplug the power

cord. Contact the manufacturer or its service agents or a similar

qualified person for service.