Installation Guide

10
DRAINAGE
During the cooling process, some water will be extracted from the air into the unit.
If the reservoir is full, both of the compressor (cooling) and motor (fan) will stop and unit will
emit a Buzz (press any button to stop the buzz); the Water Full indicator will also be
flashing.
Before cooling can resume, empty the water tank:
1. Turn off the air conditioner and avoid moving it when full.
2. Position a container (a water tray for example)
underneath the drain spout.
3. Remove the drain knob & rubber plug and allow water
to drain out.
4. When the container is almost full, replace the rubber
plug and empty the water tray. Repeat until the unit is
emptied.
5. Replace rubber plug and tighten drain knob firmly.
6. Switch on the unit –
the Water Full indicator should no
longer be flashing.
Continuous drainage (if you wish to operate the unit without the need to empty the water tank):
• Remove the drain knob and rubber plug and retain
for future use.
• Connect the supplied drain tube to the drain spout
as shown and locate the other end into a drain.
• Note the drainage is gravity-pulled, the drain tube
must not have any incline.
• The drain tube can be extended by adding an
extension tube with a suitable connector.
Note
• Drain tube must be paralleled or below outlet level.
• Flashing ‘Water Full’ indicator will not function in
continuous drainage.
• To extend the water tube, connect with another
tube (OD: 18mm)