Instruction Manual

5
Operation
Please fill the water tank as instructed below before turning on the unit.
Operating instructions:
1. ON/OFF button
Press once to turn ON unit, the power indicator will be on. Press again to turn OFF unit.
2. COOL AIR (HUMIDIFY) button
o Press once to turn on the water pump, the Cool indictor light is on; press again to turn off the
water pump and the Cool indicator light is off.
o When water level falls below “Empty”, Cool function will automatically shut off and the
indicator will flash. Please turn off this function or add water. Once water is added, cooling
function will automatically resume.
o When operating the unit without water, please keep the Cool Air / Humidifying function OFF.
The unit will operate as a normal electric fan.
3. SPEED button (total of 5 settings to choose from)
When turned ON, the unit starts on High (the H indicator light is on), to adjust:
o Press once for Medium speed (the M indicator light is on)
o Press again for Low speed (the L indicator light is on)
o Press again for Natural mode (the Natural indicator light is on)
Natural mode operates on preset computer program, alternating between different speeds to
imitate natural wind.
o Press again for Sleep mode (the Sleep indicator light is on)
Sleep mode automatically decreases the fan speed.
4. SWING button
Press the swing button to select the swinging function:
o Press once to turn on the swinging function (indicator is on), which can cover 60° horizontally
o Press again for fixed direction (indicator is off)
5. TIMER button
o Sets timer-off in increment of 0.5 hours. Timer can be set between 0.5 to 7.5 hours.
o Adding the numbers indicated equals the total time for the timer. For example: when the 0.5
and 1 indicators are illuminated, the timer has been set for 1.5 hours; when the 0.5, 1, 2 and 4
indicators are illuminated, the timer has been set for 7.5 hours.
o If none of the timer indicators are on, the unit will run continuously.
6. WATER FILLING INSTRUCTIONS
o Please be sure the power is OFF before adding water.
o Fill the water tank by pouring water and adding ice into the Ice & Water Inlet.
o The water level can be seen from the water indicator located at the lower right front panel.
o Make sure water is filled above the EMPTY mark on the water indicator.
o Pour in 2/3 of water (6 Liters) and 1/3 of ice (3 Liters) for best cooling effect.
o You can also put ice in the “Ice Box” located on the top of the unit for extra cooling (optional).
o DO NOT add more than 10 Liters of water into the water tank. The water indicator should never
rise above “Maximum” or the water tank will overflow.
NOTE: When operating the unit for the first time, please add water to the Maximum level.