Product Manual

PARTS IDENTIFICATION
INSTALLATION
WARNING: Do not plug in appliance until unit is fully assembled.
Head Assembly
1. Remove Fan Blade Cap from the Motor Shaft by turning clockwise.
2. Remove the Nut from the Motor Shaft by turning counter-clockwise.
3. Attach Rear Grill to Motor Shaft – aligning the pegs on the shaft to go through the two
openings on the grill. Attach the Nut and secure the Rear Grill by turning clockwise.
4. Place the Fan Blade onto the Motor Shaft. The fan blade will only fit on the shaft one way.
Attach the Fan Blade Cap and secure fan blade by turning counter-clockwise.
5. Front Grill: position the small forked tab over the center grill spoke of the Rear Grill. Gently
snap the front and rear grills together.
Fan Assembly
1. Install the Extension Tube onto the head assembly and secure by tightening the Lock Nut.
2. Attach each leg to the Shaft Base’s Attachment Points, tighten screw to secure.
FRONT
GRILLE
NUT
FAN BLADE
GRILLE
LOCK
SHAFT BASE
LEG ATTACHMENT POINTS
THREE-
LEGGED
BASE
GRILLE SET
(FROTN & REAR)
REAR GRILLE
OSCILLATION KNOB
MOTOR HEAD HOUSING
MOTOR HEAD
HEAD
HEAD REST
LOCK NUT
EXTENSION TUBE
HEIGHT LOCK NUT
POWER CORD
RUBBER FEET
COVERS