Product Manual

4
B. Blade Assembly
1. First, remove the following parts from the axle on the
motor head. Please remove before installing grilles:
Guard Lock Nut, Axle Sleeve and Lock Cap.
2. Place the Rear Grille on the axle.
3. Place the Guard Lock Nut and tighten by turning clock-
wise.
4. Place the Axle Sleeve on the Axle.
5. Insert the Fan Blade on the Axle
6. Place the Lock Cap and tighten by turning clock-wise.
7. Install the Front Grille.
• Align the clip on the top of the front grill and clip it to
the rear grille.
• Press down firmly at the six points as indicated.
• Snap close the bottom clip
OPERATING INSTRUCTIONS
Fan Head Oscillation: Press down the Oscillation knob.
Fixed Direction: Pull the Oscillation knob up.
The vertical and horizontal angles of the fan head can be manually
adjusted
To Adjust the height of the stand: Press down on the Height Lock and
adjust height. Release when desired height is reached.
The base includes a section to store the power cord, when unit is not in
use.
To operate timer-off, turn Timer Dial accordingly.
To operate continuously, turn Timer Dial to ON position.
Fan Speed selection:
0 = OFF
L = Low Fan Speed
M = Medium Fan Speed
H = High Fan Speed
Axle
Guard
Lock Nut
Axle
Sleeve
Lock Cap
Axle
Rear Grille
Guard
Lock Nut
Guard
Lock Nut
Fan blade