Instruction Manual 2.4 CU. FT.
Contents 1. SAFETY WARNINGS............................................................................................................ 1 2. INSTALLTION...................................................................................................................... 2 3. PRODUCT OVERVIEW ........................................................................................................ 4 4. OPERATION.............................................................................................
1. SAFETY WARNINGS Caution: risk of fire 1) WARNING―Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. 2) WARNING―Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. 3) WARNING―Do not damage the refrigerant circuit.
2. INSTALLTION 2.1 Location When selecting a position for your unit, please make sure the floor is flat and firm. The room should be well ventilated with an ambient room temperature between 61°F and 100°F. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold temperatures may cause the unit not to perform properly. This unit is not designed for use in garage or outdoor installation.
4) Place to one side. 5) Slide the door downwards and off the top hinge pin. Lift and remove door, place to side. 6) Remove the two screws from top bracket and transfer to the other side. You will need to first remove the plastic caps on the other side. 7) Slide the door back onto the top hinge, be sure the door is the right way up. 8) Screw the bottom hinge into place on the new side. 9) Place the foot on the other side. 10) Cover the top of door hinge with plastic cover by gently pushing into position.
2.5 Cleaning Before Use Wipe the inside of the unit with a weak solution of baking soda. Then wipe with a “wrung-out” sponge or cloth with warm water. Wash the shelves and door bin in warm soapy water and dry completely before replacing in the unit. Clean the exterior of the unit with a damp cloth. If you require more information refer to the Cleaning section. 2.6 Before Using Your Unit Before placing any food in your unit, turn it on and wait for 24 hours to make sure it is working properly.
4. OPERATION 4.1 Adjusting the Temperature • • • • • • • • OFF = Power off 1 = Least cool temperature setting 3 = Normal operation (suggested setting for most situations) 6 = Coldest temperature setting During high ambient temperatures e.g. on hot summer days, it may be necessary to set the thermostat on the coldest setting (6). This may cause the compressor to run continuously in order to maintain a low temperature inside the cabinet.
5. CLEANING Defrosting 5.1 • • • • • Defrost the unit when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick. Set the thermostat dial to “OFF” position. Remove frozen or perishable foods from the chiller compartment and place it in a cooler to protect the food. During the defrost cycle, the ice melts into the water drip tray. To remove the water, either remove the water drip tray and/or place a collection container under the tray.
6.3 Servicing The unit should be serviced by an authorized engineer and only genuine spare parts should be used. Under no circumstances should you attempt to repair the unit yourself unless instructed how to do so. Repairs carried out by inexperienced persons may cause injury or serious malfunction. 6.4 Vacation / Storage If the unit is not to be used for a long period of time, turn the thermostat to OFF position and unplug from power source. Empty all contents and clean the appliance.
• • • • • • • • • • Check the unit’s ventilation periodically to ensure adequate air circulation behind the unit. In normal temperature conditions, please set the thermostat at the middle setting. Before loading the appliance with packages of fresh food, make sure they are cooled to ambient temperature. Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3-5 mm thick. Keep the rear (condenser) free of dust and impurities.
If this product is defective Or not working properly Please DO NOT return to your retail store Please contact us directly with any Service or Technical Assistance Contact us toll free at: 1-800-330-0388 9
Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms: • Sunpentown must be notified of the fault. • Proof of purchase must be presented to Sunpentown’s nominated representative.
