manual
This appliance features an Auto-Clean function: each time the unit is powered
on, the rst cycle of water will be pulled out; ice making will begin with the
second cycle.
When using your ice maker for the rst time (or after a period of inactivity), it
is suggested to discard the rst four batches of ice to ensure machine is
thoroughly clean.
1. Connect the ice maker to a grounded outlet.
2. Press the Power switch to the ON position (I). The switch light illuminates
and unit begins operation. The unit will go through a ve minute self
inspection process. Then it will begin the ice making process.
Notes:
• As soon as the ice storage cabinet is full the ICE FULL indicator on the
display panel will illuminate and ice maker will stop automatically. Ice
production resumes once ice has been removed from the cabinet.
• If water supply is insufcient, the WATER LOW indicator will illuminate
and ice maker will stop operation. Check water supply.
1. Install the Squeeze Hose Clamp to one
end of the Water Drainage Pipe.
2. Connect the end with the clamp to the
Drain Outlet located at the rear of the ice
ice maker. Be sure the clamp is rmly
over the drain hose and drain spout
connection (refer to image on right).
3. Attach the other end to drain receptacle.
4. Connect one end of the Water Inlet Tube to your water source. Connect
the other end to the Water Inlet located at the rear of the unit.
Note: Be sure to use sealing washers on both ends of the Water Inlet tube.