manual
Before connecting power, please allow unit to stand upright for at least 24
hours to allow the refrigerant to settle.
• Remove all packaging materials: protective lm, shipping tape, glue, etc.
• Remove the Ice scoop, water inlet tube, water drainage pipe and washer
from the storage cabinet.
• The unit should be located on a rm and level surface that can support
the ice maker’s total weight with water/ice.
• This unit is designed for free-standing application, allowing you to install
the unit anywhere provided the requirements for clearance, water and
electrical are met.
• This unit must be placed in a well ventilated area with temperature between
50°F and 100°F, with at least 7 inches of space around the back and
sides for proper air circulation.
• Do not place unit next to ovens, grills or other high heat sources.
• Position the unit so that power and water supply is accessible.
• If necessary, adjust the leveling legs. Efciency of the ice maker can be
reduced if unit is unevenly located.
• Not all the necessary hardware is PROVIDED for water inlet installation
(as the plumbing xtures at the installation point may differ). So it is
necessary to hire a professional plumber to complete the installation.
• For unit’s longevity, use of ltered or puried water is required; or
unit must be cleaned once every other week with citric acid to remove
mineral build up.
Electrical Requirements
Read all safety precautions listed at the beginning of this manual. It is
recommended to use a dedicated circuit for this ice maker. Do not use
receptacles that can be turned off by a switch or pull chain.
The ice maker is equipped with a 3-prong grounding plug. To minimize
possible shock hazard, the cord must be plugged into a mating 3-pronged
and grounding-type wall receptacle. Do not cut or remove the ground prong.
If a mating wall receptacle is not available, it is the responsibility of the
customer to have a properly grounded 3-prong wall receptacle installed by
a certied electrician.
IMPROPER WATER LINE CONNECTION MAY RESULT IN FLOODING.
YOU MUST USE A LICENSED PLUMBER
REVIEW STATE AND LOCAL PLUMBING CODES BEFORE INSTALLATION