Instruction Guide

Sunpak® Infrared Heaters
10

YoumustremovetheSunpakFaceTrimtoconnectpowertotheheater.TheSunpakFaceTrimissecuredwith
four(4)screws,two(2)locatedalongeachsideoftheheater.


BasicWiring
SunpakS34‐TSRrequires7.5VDCforitscontrols.Inmostcasesyouwill
berunninglowvoltagewirefromthePowerAdapterpluggedintoa120
VACoutlet.ThePowerAdapterisnotwaterproofandmustbeweather
protected.Theextensionwirecanberun50feetwith18
GAandmust
havesuitableoutdoorinsulation.Inordertoaddtheextensionwireyou
must:
1. RemovetheFaceTrim
2. DisconnectthePowerAdapterfromthecontrolmodule.
3. Attachtheslideconnectortotheextensionwire.
4. Connectoneendoftheextensionwirecabletothe
moduleand
theotherendtothePowerAdapter
WARNING:DonotattachtheExtensionCabledirectlytothe120VAC
Outlet.
NOTE:MaleandFemaleconnectionsaresuppliedintheextensionkit
suppliedwitheachheater