Installation guide

ManualsBrandsSunpak ManualsOutdoor Living48" Outdoor Infrared Heaters with Two Stage Hardwired, Ceramic Infrared Burner System, Direct Spark Ignition, in Black

Printed in USA



SunpakS34‐TSH

OutdoorGasInfraredPatioHeater

NOTFORUSEINRESIDENTIALDWELLINGS

Installation,Operationand&MaintenanceInstructions



NOTE:HeateraboveshownwithoptionalFaceTrim

Installer: Please take the time to read and understand these instructions prior to installation. Installer

must provide a copy of this manual to the owner.

Owner: Keep this manual in a safe place in order to provide your service technician with the

necessary information.

Warning:

These instructions are intended for qualified personnel, specifically trained and experienced in the

installation and repair of this type of equipment and related system components.

WARNING: California Proposition 65

IF NOT INSTALLED, OPERATED AND MAINTAINED IN ACCORDANCE WITH THE

MANUFACTURER’S INSTRUCTIONS, THIS PRODUCT COULD EXPOSE YOU TO

SUBSTANCES IN THE FUEL OR FROM COMBUSTION INCLUDING CARBON

MONOXIDE WHICH CAN CAUSE DEATH OR SERIOUS ILLNESS AND WHICH

ARE KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH

DEFECTS OR REPRODUCTIVE HARM.

For more information

o to www.P65WARNINGS.CA.GO



InfraredDynamics,Inc

3830ProspectAvenue

YorbaLinda,CA92886

http:\\sunpak.us

ForLocalDistributorListing

CallUsTollFree

(888)317‐5255

Summary of content (15 pages)

PAGE 1
Sunpak S34‐TSH Outdoor Gas Infrared Patio Heater NOT FOR USE IN RESIDENTIAL DWELLINGS Installation, Operation and & Maintenance Instructions NOTE: Heater above shown with optional Face Trim Installer: Please take the time to read and understand these instructions prior to installation. Installer must provide a copy of this manual to the owner. Owner: Keep this manual in a safe place in order to provide your service technician with the necessary information.
PAGE 2
Sunpak® S34-TSH Infrared Heaters Table of Contents 1. Sunpak heaters work like the sun Warnings projecting radiant heat down to warm your patio and guests. This heater was designed for outdoor installation; however, breezes will affect the heating efficiency, and severe weather conditions will cause the safety system to shut down the heater. For your safety you must read and understand the following warnings before continuing. 2. Basic Operation 3. Heater Layout and Design 4. Installation / Service 5.
PAGE 3
Sunpak® S34-TSH Infrared Heaters Basic Heater Operation Sunpak® S34‐TSH is a two‐stage outdoor gas‐fired infrared heater which is operated with a wired switch. The heater can be operated at a HIGH setting with an input of 34,000 BTU/Hr or at a LOW setting of 25,000 BTU/HR. These heaters require a 24 VAC power source. The fact that these heaters are hardwired to a three‐way switch makes the S34‐TSH well suited for commercial installations. There are no batteries or remote‐control devices to be misplaced.
PAGE 4
Sunpak® S34-TSH Infrared Heaters Patio Design Consideration Heater Layout and Design Sunpak® heaters were specifically designed to provide heated comfort in an outdoor environment. They have been used on outdoor patios across the United States and Canada for over 30 years. When properly integrated into a patio design, Sunpak® heaters generally increase the comfort level 5º to 10º Fahrenheit outdoors. The heating effectiveness will depend on air temperature, wind velocity and other factors.
PAGE 5
Sunpak® S34-TSH Infrared Heaters Sunpak® Infrared Heater Location Poor heater installation. Locate heaters to offset heat loss. Cold airflow Cold air flow ~ _____. _____. ~ CLUSTER ARRANGEMENT Cold air flow Heaters are placed in groups, facing away from each other using a maximum 30 degree angle. +-- Maintain.....---" UNIFORMLY SPACED /!~,~~~ Cold air flow Heaters are placed evenly along the roof ____.-. with no angle.
PAGE 6
Sunpak® S34-TSH Infrared Heaters Warning: Heater must be level in the lengthwise direction.
PAGE 7
Sunpak® Infrared Heaters Gas Supply Installation/Service Instructions The gas inlet supply pressure and manifold pressures required for each heater are listed below. For gas supply line pressures in excess of ½ PSI, consult with your gas service provider or the factory. Receiving Equipment On receipt of equipment it is suggested that a visual inspection be made for external damage to the carton. If the carton is damaged, a note should be made on the Bill of Lading when signing for the equipment.
PAGE 8
Sunpak® Infrared Heaters Gas Piping 1. 2. 3. WARNING 4. Suspension Hazard Mounting kits and hanging supports must be able to withstand a minimum working load of 75 lbs. (33 kg). Failure of the supports can result in death. 5. 6. Local codes regarding head clearance requirement must be observed. 7. Heater Mounting and Support Heaters shall be mounted in a fixed position independent of gas and electrical supply line. Hangers and brackets shall be of noncombustible material.
PAGE 9
Sunpak® Infrared Heaters Ventilation 1. 2. 3. It is required that areas above the heater be properly vented to allow for necessary combustion air and removal of combustion gases. Heaters shall be provided with natural or mechanical means to supply and exhaust at least 4 cfm per 1,000 BTU per hour of heater input. Exhaust openings for removing the flue products shall be above the level of the heaters. Heater ventilation must comply with state and local codes. Never use heater in a fully enclosed area.
PAGE 10
Sunpak® Infrared Heaters Optional Face Trim can be easily installed on all Sunpak models You must remove the Sunpak Face Trim to connect power to the heater. The Sunpak Face Trim is secured with four (4) screws, two (2) located along each side of the heater.
PAGE 11
Sunpak® Infrared Heaters 11
PAGE 12
Sunpak® Infrared Heaters 12
PAGE 13
Sunpak® Infrared Heaters 13
PAGE 14
Sunpak® Infrared Heaters Basic TSH Trouble Shooting Problem Possible Causes How to Fix No Spark to pilot No blue indicator light on switch  Verify power to switch    Replace Switch Switch is On Verify wiring is properly connected to the heater module No Gas to Heater    Allow time for air to bleed from gas line on new installations Turn on manual gas valve Clean burner orifice Low Voltage  Make sure you have 24 VAC to heater Loose or broken ground wire inside control compartment 
PAGE 15
Sunpak® Infrared Heaters Limited Warranty THIS WARRANTY IS APPLICABLE TO THE ORIGINAL OWNER ONLY, in accordance with the warranty terms and conditions specified below. Infrared Dynamics (the warrantor) will furnish at our option the ORIGINAL OWNER, 1) a replacement Infrared Dynamics’ heater or 2) a replacement part for any component part which fails before one year when for residential use. When the heater has been used for other than single family residential applications, the warranty shall be 90 days.