User's Manual

Manual flash mode M
When you need to manually exposure, You can set the flash brightness
according to your own needs. From 1/128 power to 1/1 full power to adjust
the incremental setting the flash output.
1.Press 【 MODE】 button
2.until the LCD display M.
Select the flash MODE
Power setting
Use the Left and Right buttons to manually
set output power value.The Left Button
will decrease down to 1/128 and the Right
Button will increase to 1/1 (full power).
Stroboscopic flash mode(Multi)
To properly use Multi mode, set the camera in the M mode. When you using
the Multi mode, there will emit a series of quick flash, it can undertake
Multiple flash in a photograph, a series of actions in order to freeze.
Commonly used when shooting a moving object, Please set the flash output
power as required, Times of flash and Flash frequency (Every flashes time
show by Hz). Please use the new batteries or fully charged battery operating
this mode. To prevent flash unit overheating and damage, do not perform
1/X sec.is the camera's maximum flash sync speed.
Note: The Canon camera mode: P, TV, AV, M, A - DEP, green frame
Nikon mode: P, S, A, M
Right: 1/128 → 1 /64 →1 / 32 →11/ 16 → 1/8 → 1/4→ 1/2 → 1/1
Left : 1/ 1 → 1/2 →1 /4 → 1/8 → 1/ 16 → 1/32 → 1/64 → 1/128
15 16
1 2-
1 4/
1 4-
1 8/
1 8-
1 16/
1 12-
1 32/
1 20-
1 64/
1-40
1/128
Press 【MODE】 button
until the LCD display .
Frequency setting
Press the Setting/Select Button and the Hz will
flicker. Adjust using the Left or Right buttons, then
press the Settings/Select button to set. You can adjust
the flash frequency from 1 Hz - 199 Hz.
The number of flashes set
Next, press the Settings/Select button and adjust the
number of flashes using the Left and Right buttons.
Depending on the Manual Power Ratio, you can
adjust the number of flashes from 1 to 40. Once you
have reached your desired number of flashes, press
the Settings/Select button to exit.
battery or the full battery operating this mode.
Exposure power setting
Press the Setting/Select button again to delect the
power. Use the Left and Right buttons to choose from
1/128 power up to 1/4 power.
The relational table of flash power and times of flash
Flash power
Times of flash
more than 10 consecutive frequency glint light shoot. Between exposure
operation, please let the flash have enough time to call back. If you try to
execute more than 10 consecutive frequency glint light shoot. In order to
prevent flash unit overheating, flash can Automatically stop. If this situation
happened, please let flash cooling for at least 15 minutes.Please use a new
Select the flash mode