User Manual

Install flash to camera
1.
Prepare to install the fkash
According to the direction indicated by an
arrow will spin lock dial to the left side.
2.
Install the
flash
According to the direction indicated by an
arrow will flash installed foot completely
inserted into the camera's hot shoe.
3.
Lock the
flash
According to the direction indicated by an
arrow will spin lock dial to the right to lock
the
flash.
4.
Remove the flash
According to the direction indicated by an
arrow will spin lock dial to the left side, and
slowly remove the flash from the hot shoe
Make sure the flash and camera power are off.
Don't pull out forcibly!
9 10
Turn on the power
Press the Power button (ON/ ) for
two seconds to turn on/off the flash.
OFF
In order to save battery power and avoid battery leakage,The default setting is as
follows:
After the DF3600U is turned on and there is no activity or no functions
working within 60 seconds,the CPU will go into Sleep Mode. In this case press
any button to wake up the flash. If the DF3600U is not used for a long period
time, it is recommended to use the main power switch to turn off the flash and
remove the power source (batteries). Before removing the batteries, turn off the
power of the DF3600U flash. After the DF3600U's capacitor is fully charged,
the DF3600U's flash ready indicator button （ ） lights up, indicating that the
flash is ready to trigger. This means that the DF3600U can be used for the next
shoot.
State of charge indicator
Before shooting, confirm the flash charging
and camera viewfinder lights indicator lights
have been lit.
External power supply by extending the interface and complete PC sync.
In order to save battery power and avoid battery leakage,The default setting
are as following: