User Manual

Applicable batteries and power supply.
The following batteries are applicable to the flash.
1, AA battery
A:4 (AA) Alkaline manganese battery (1.5V). The battery can meet demand
of medium power without maintenance, but it can not be recharge.
B:4 (AA) Nickel-cadmium battery (1.2V). The battery recycles quickly and
can be recharged, so it is economic and practical.
C:4 (AA) Nimh batteries (1.2V). This battery's power obviously exceed that
of nickel-cadmium battery and it is less harmful to the environment (do not
contain cadmium).
D:4 (AA) Lithium battery (1.5V). This battery has large capacity. Low
self-discharge rate and no need of maintenance.
E:4 (AA) Hydrogen oxygen cell (1.5V). This battery is also called (Oxyride),
Its capacity is larger and its service life is about 1.5 times of alkaline battery's.
So it is very Suitable for use in electronic products of high power consumption.
Install the battery
Lithium battery installation
1, Open the battery cover.
According to the direction of the
arrow shown in slide battery hatch
cover, open the battery compartment.
2, Install battery
According to the battery polarity
located on the indise of the battery
cover, install the battery into battery
compartment
. Make sure the battery
polarity contact is correct.
3, Close the battery cover.
Closed it according to the direction
of the arrow shown in slide the
battery cover.
7 8