User Manual

31 32
Specification
Circuit design: Insulated gate bipolar transistor (IGBT)
Guide Number: 118 (ISO100,180 mm)
Flash coverage: Manual/Automatic zoom18 ~ 180 mm
TTL flash mode: Automatic mode, Manual mode M, Stroboscopic mode
Multi, LED lighting, canon master,Nikon Master models,
Slave light SLAVE c, SLAVE n, Light flash mode S1, S2,
Surrounded by flash exposure (FEB)
Wireless trigger: Light pulse, Induction flash light
Wireless flash distance: Indoor 20 ~ 30 meters, Outdoor 10 ~ 15 m
Support the subordinate unit: 4 communication channels (1, 2, 3, 4) and
3 SLAVE unit group (A, B, C)
Rotation Angle: Up and Down - 7 ~ 90 degrees
Left-Right /Right-Left rotation Angle: 0 ~ 180 degrees
Color temperature :5500K
Flash time: 1/200s-1/20000s
Manual flash control: 1/128-1/1 step 0.3 EV, a total of 22 grade fine-tune
gear
External interface: Hot Shoe, PC sync interface, External interface DC
power supply
Recycle time : 2.3 seconds
Power supply: 4 AA Batteries,
Flashes :(A set of full working hours when the maximum and minimum
power battery) Flash number for 500-5000 times
Additional features: Power saving mode, Overheating protection
Size : 7.87" H x 2.95" W x 2.24" D
Weight : 13.2 oz. (without batteries)
Flash head rotation to achieve reflection flash
Sunpak One Year Warranty:
This Sunpak product has been carefully manufactured, accurately adjusted,
inspected and thoroughly tested before shipment to assure you of the highest
quality. Should this Sunpak product require service, we will repair or
replace, at our option, any part, or the product itself, which our examination
shows to be defective in material or workmanship. This warranty does not
apply to wear and tear associated with the normal use of the product. This
warranty is non-transferable.
Repairs will be made to the product at no charge, under the terms of the
warranty as stated above, only when accompanied by a copy of your dated
and itemized sales receipt. Be certain to follow all assembly and/or operating
instruction with this product.
This warranty is not valid if the product has been misused or damaged in any
way that is beyond our control or through normal wear and tear associated
with its use. This warranty only applies to the product and we are not
responsible in any way for losses, damages or any inconvenience caused by
equipment failure.
Some states do not allow the exclusion or limitation of consequential
damages, so the above limitation or exclusion may not apply to you. This
warranty gives you specific legal rights and you may have other rights which
may vary from state to state.
Should service be required, the product should be carefully packed and sent
pre-paid and insured to the address listed below. A note describing the nature
of the defect should be enclosed to expedite handling. Proof of purchase
must be included for all warranty repairs.
Sunpak
ToCAD America Inc.
53 Green Pond Road
Rockaway, NJ 07866, USA
www.tocad.com