User Manual

29 30
Bounce Flash
Reflection flash is by putting a flash head toward the wall or ceiling, flash
be metope reflect in front of the illuminated by the object. This can reduce
the shadow on the reverse of the subject object, in order to obtain more
natural photographic effect.
Adjust the flash head tilt, rotation Angle and select the reflection
plane
When the flash head thrown back and
White Ceiling
the ceiling as the radiation surface,
can usually be the most simple to
obtain good results. Holding camera
longitudinal, horizontal select flash
can obtain the same effect.
Note that do not flash direct exposure
to the subject. Between flash head and
reflection plane .The effective distance is 1 m to 2 m, depending on the
shooting environment. Shoot color photos, please choose white or
reflective plane reflection flash. Otherwise,When taken photos will
appear unnatural color.
Use the built-in reflex plate
Application of reflex flash when
shooting, use the built-in reflection
board, can make the main body more
bright and existence of vitality.
Meanwhile it can avoid to light the
front of the foreground objects.
1, The flash head up
90 degrees.
2, Pull out wide
diffusion plate as
well as pop-up
reflection card at
the same time.
3,Keep reflecting
cards with wide
diffusion plate, only
push wide diffusion
plate
Use the built-in wide-angle diffuser
When the camera to the subject's distance is less than 2m, you can use the
wide angle diffuser plate more naturally close-up. Can also use the built-in
wide-angle diffuser will flash coverage expanded into a wide angle.
1.Pull out wide diffusion plate
Slowly pull completely wide diffusion
plate, then put it in the flash head.
2.Push the reflector plate
At the same time to push reflection piece
into the flash head.