User Manual

21 22
Wireless instruction model (SLAVE c /SLAVE n )
SLAVE c: means receive Wireless flash sign from Canon 7D/60D/60c
camera bulid-in flash and 580EX II、600EX、ST-E2 and the Vice factory
MASTER wireless flash signal.
SLAVE n:means receive C instruction sign from Nikon camera bulid in
flash instruction and SB-900/800/700、SU-800 and the Vice factory
MASTER command signal signal
SLAVE c/n: support 4 channels ,3 different group ,TTL ,Manual and Multi
Wireless flash by this model.Rotate flash light head in order to wireless
S1 S2
Note:
1, Short press 【Flash model select button】 only change SLAVE flash model
in Wireless SLAVE flash model.If the flash is connected to the camera, press
the shutter button, the flash will not be connected with the camera, and it needs
to manually exit the wireless slave mode to perform the online operation.
2, Under SLAVE mode, you can through the custom function (Fn-08) on the
AF assist light flash close, exit wireless SLAVE mode, need to use the focus
lamp, please enter custom settings page to re open the AF assist lamp.
3, System standby 60 seconds after the flash will not enter the dormant state.
·To correctly use the wireless command mode, you must setting
communication channel and group by correct.
Note:
·Flash light and model in Wireless instruction Parameter in Wireless
instruction mode can't setting directly.It's only can setting by
MASTER light.
trigger to MASTER light.Before shooting ,we need set up the same channel
about flash light and MASTER light.
Short press (Zoom button): until channel or group twinkle as for SLAVE
unit ,setting Communication channel of SLAVE unit (1.2.3.4) and SLAVE
unit group (A.B.C)
When working in a SLAVE unit, the flash light and mode are completely
controlled by the MASTER control unit and display the received
information;