Instructions / Assembly

B
A
LL
KK
GG
HH
HH
Regulator
D
C
Page 8 / 15PH02
As shown, secure the reector assembly to the top
of the reector studs on the head assembly using six
Washers (HH) and three Wing Nuts (GG).
Unscrew the four screws that are preassembled on
the Head Assembly (C).
Run the regulator on Head Assembly (C) through the
top of Post (D).
Using the previously removed screws, tightly fasten
Post (D) to Head Assembly (C).
8
9 Attach head assembly to post
Align three Reector Panels (A) and a󰀩x the outer rim
using three Small Screws (LL) and three Nut Caps
(KK).
Align Center Reector (B) in the center of the reector
panels and fasten using six Small Screws (LL) and six
Nut Caps (KK).
Tighten all screws tightly.
7
WARNING: Remove plastic protective
coating on the reector panel (A) and
center the reector (B) before assembling!
08/2021